SEKURE SX-3100LCD Manuel de l'opérateur télécharger pdf (Page 312)

100

101

300 OBD II

MULTIPLE ECU STATUS INFORMATION

When viewing multiple OBD II ECU diagnostic data parameters, the symbol “=” or “>”

before the parameter name indicates the parameter is being updated by multiple ECUs.

The “=” symbol indicates the displayed parameter value is being reported as the same

value by multiple ECUs. The “>” symbol indicates the displayed parameter value is not

being reported as the same value by multiple ECUs. If there is no symbol before the

parameter name, the parameter is being updated by a single ECU.

The following table lists the tolerances for the different parameters being labeled “=” or

“>”. Multiple parameters that are within the tolerances are reported as being the same.

Multiple parameters that are not within the tolerances are reported as being not the same.

Bx = Bank number

Sx = Sensor number

CHARACTER STATUS

= Indicates multiple controllers are reporting approximately

the same value for the parameter.

> Indicates multiple controllers are reporting different

values for the parameter.

PARAMETER TOLERANCE

Engine Load 1.96%

ECT 5 °C

ST FT 1/ ST FT 2 3.91 %

LT FT 1/ LT FT 2 3.91 %

Fuel Pressure 15 kPaG

MAP 5 kPa

Engine Spd 2.5 RPM

Vehicle Spd 5 kph

Ign. Timing 2.5°

IAT 5 °C

MAF 0.1 gm/s

TPS 1.96%

O2S Bx Sx 0.025 V

FT O2S Bx Sx 3.91%

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 377 378

Commentaires sur ces manuels

Pas de commentaire

SEKURE SX-3100LCD Manuel de l'opérateur Page 312

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité SEKURE SX-3100LCD