SEKURE SX-3100LCD Manuel de l'opérateur télécharger pdf (Page 198)

186 OBD

VOLTAGE

Press 2 to select <VOLTAGE> from the <AUTOPROBE MENU>. The Voltage mode

allows you to use the Autoprobe as a volt meter.

Measurement voltage is frozen by pressing the switch on the Autoprobe. Pressing the

switch again displays normal voltage.

ACTIVE KEYS

E Reset the Maximum and Minimum values to 0.0V.

x Return to the <AUTOPROBE MENU>.

FREQUENCY

Press 3 to select <FREQUENCY> from the <AUTOPROBE MENU>. The Frequency

mode allows you to use the Autoprobe as a frequency counter.

Measurement frequency is frozen by pressing the switch on the Autoprobe. Pressing the

switch again displays normal frequency.

ACTIVE KEYS

x Return to the <AUTOPROBE MENU>.

E Resets the Maximum and Minimum values.

DUTY CYCLE

Press 4 to select <DUTY CYCLE> from the <AUTOPROBE MENU>. The Duty Cycle

mode measures the widths of the high and low signals and displays this value as a

percentage.

The <HIGH> value indicates the longest amount of time that the signal was in the

<HIGH> state. The <LOW> value indicates the longest amount of time the signal was in

the <LOW> state. The Duty Cycle value indicates the percentage of time the signal was in

the <LOW> state.

Measurement duty cycle is frozen by pressing the switch on the Autoprobe. Pressing the

switch again displays normal duty cycle.

ACTIVE KEYS

E Reset Minimum\Maximum, High\Low values.

! Switch between Minimum\Maximum and High\Low display.

x Return to the <AUTOPROBE MENU>.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 377 378

Pas de commentaire

SEKURE SX-3100LCD Manuel de l'opérateur Page 198