Superbus Alphanumeric Touchpad
Page 2
Tools Needed
ν Screwdriver
ν #6 screws and anchors
ν Panhead screws for a gang box installation
ν Sheetrock knife or saw for cutting wallboard in
wall installations
Note: Do not use screws larger than #6 or the display
will not seat correctly onto the back plate.
Installation
The Superbus Alphanumeric Touchpad can be
installed on a wall or gang box.
To mount the touchpad on a wall:
1. Separate the back plate from the display by press-
ing the release tab and pulling it down.
2. Place the back plate on the wall and mark the four
wall-mount holes (see Figure 1). Be sure to leave a
one-inch clearance on all sides of the back plate.
Figure 1. Wall and Gang Box Mounting Holes
3. Insert anchors at the marked locations.
4. Align the back plate wall-mount holes with the
installed anchors and secure the back plate to the
wall with the included screws.
5. Cut a hole in the wall along the inner right edge of
the mounting plate to pull your cable through for
terminations.
To mount the touchpad on a gang box:
1. Separate the back plate from the display by press-
ing the release tab and pulling it down.
2. Line up the gang box mounting holes with the
gang box holes (see Figure 1).
3. Secure the back plate to the gang box with the
included screws.
Note: Do not overtighten screws or the back plate may
bind and prevent the display from mounting cor-
rectly.
Wiring
Wiring consists of connecting the touchpad’s wiring
harness to the panel terminals and connecting a
hardwire sensor to the hardwire input harness wires.
Wiring the Touchpad to UltraGard and
Custom Versions
To wire the touchpad’s wiring harness to UltraGard
and Custom Versions:
1. Turn off the panel power switch.
2. Run a 4-conductor, 22-gauge or larger stranded
wire from the touchpad location to the panel.
3. Connect the wires to the panel terminals and wir-
ing harness as shown in Figure 2.
Note: Do not connect wiring harnesses to any touch-
pads at this time.
Figure 2. Alphanumeric Touchpad Wiring
To connect a hardwire sensor to the hardwire input
BACK PLATE
GANG BOX
MOUNTING HOLES
RELEASE TAB
8557G09A.DS4
WALL
MOUNT
HOLES
WALL
MOUNT
HOLES
8557G10A.DS4
12
13 14 15
GND
DC
OUT
BUS
B
BUS
A
YELLOW
NOT USED
BLACK
RED
WHITE
GREEN
WIRING
HARNESS
49-283
TAB SLOT (4)
N/C LOOP
SWITCH
WITH MAGNET
CONTROL PANEL
(47 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels